Joined: July 2004
||Posted: 27 Aug. 2019,12:25
while it's always good to point what you lay on the day, for DIYers this can be something of a problem, as they won't be expecting to lay the tens or hundreds of square metres a professional team would expect to install in a typical day. So: for such situations, and on a relatively small job such as this, I'd be more than content to see it all jointed in one operation on completion.
If you are *very* careful, you can walk across freshly laid paving around 24 hrs after laying, but, it must be done with caution. Walk gingerly, keep away from edges and corners of the individual flags, aiming to step on the centre of any flag, and walk on as few as possible. After 3 days, you should be far safer, but, again, keep to the centres of flags until it's all jointed.
A single bucket of 850+ *should* give you around 12m² of coverage, but I have seen it stretched to 16-18m² on a few jobs. It's all down to joint width and depth, of course. If I were doing this, I'd invest in two buckets, make sure the joints are raked out prior to jointing to give as much depth as possible, and accept that I'm likely to throw away half a bucket of not inexpensive mortar.
I have seen children of DIYers (and of contractors) comandeer surplus resin mortar and use it with moulds to make all sorts of weird and wonderful "models". I've seen rabbits (I think that was a jelly mould), no end of starfish, seahorses and crescent moons made using beach toys, and quite a few cubes, spheres and pyramids....now there's an idea for a page on the new website: things to do with leftover resin mortar!
Site Agent - Pavingexpert